Roll Paper Supply Module; Roll Paper Holder Unit Specifications; Roll Paper Holder Unit Adjustment Method - Star Micronics TUP500 Series Product Specifications Manual

3.6. Roll Paper Supply Module

3.6.1.

Roll Paper Holder Unit Specifications

(1) Roll Paper Support Method: Shaft Support Method Using the Roll Paper Holder
(2) Paper Width Adjustment:
(3) Paper Tube:
Refer to section 3.6.2 for details.
Paper Tube
Inner Diameter Ø1 Inch Paper Tube
Inner Diameter Ø2 Inch Paper Tube
Inner Diameter Ø3 Inch Paper Tube
3.6.2.

Roll Paper Holder Unit Adjustment Method

(1) Adapter Mounting
Depending on the diameter of the paper tube of the roll paper you use, it may be necessary to
mount the corresponding adapter to the roll paper holder (fastened side, movable side). Refer to
table below to make the appropriate settings.
Also, see Fig. 3.6.2.1. for the adapter mounting method.
Paper Tube
Inner Diameter Ø1 Inch Paper Tube
Inner Diameter Ø2 Inch Paper Tube
Inner Diameter Ø3 Inch Paper Tube
F ig. 3.6.2.1. A dapter M ounting on the R oll P aper H older
Notes:
1. Adapter L is an accessory of the optional damper roller B unit (DRU-T500B), so if using the
roll paper inner diameter Ø3 inch paper tube, purchase the optional damper roller B unit
(DRU-T500B).
TUP500 Series Product Specifications
(Fixed Shaft Unit)
Adjustable to any width between 45 mm to 82.5 mm.
See table below. Note that an adapter is necessary, depending
on the paper tube.
Paper Tube Diameter
Ø25.4 ±1 mm
Ø50.8 ±1 mm
Ø76.2 ±1 mm
Paper Tube Diameter
Ø25.4 ±1 mm
Ø50.8 ±1 mm
Ø76.2 ±1 mm
3-18
Adapter
None
Mount Adapter M
Mount Adapter L
Position with Notch
Screw Hole