Star Micronics TUP500 Series Product Specifications Manual page 19

9) Pre-printing Range on the Backside of Paper See table below.
When pre-printing to the backside of recording paper, it should meet the following specifications.
P rint D irection
Notes:
1. When using paper used to pre-print, adequately check operations on the actual layout and
print media.
2. If out of the above specifications, the paper detector (sensor) may mis-detect paper, or not
detect at all.
3. When using thermal paper implemented with pre-printing, always evaluate on the actual
machine, before use.
(10) Effective Paper Width:
memory switch. The representative paper widths are outlined below.
Paper Width (mm)
45±0.5
57.5±0.5
79.5±0.5
82.5±0.5
TUP500 Series Product Specifications
C enter of P aper W idth
9 m m
F ig. 3 .3.1 .12 P reprinting Range
The effective print width adjustment can be made by setting
Left/Right Margins
4 mm per side: Total 8 mm
4 mm per side: Total 8 mm
4 mm per side: Total 8 mm
4 mm per side: Total 8 mm
1.25mm per side: Total 2.5 mm
-
Effective Print Width
37mm
50mm
72mm
74mm
80mm *
3-12
B ackside of Paper
No Preprinting
(TUP592)
B ackside of Paper
No Preprinting
(TUP542)
From Paper Edge
Min. 15 mm