Star Micronics TUP500 Series Product Specifications Manual page 27

Supports 57.5mm paper width
See Fig. 3.6.2.2.D. for the roll paper holder (fastening side) setting position to handle paper widths
of 57.5mm.
Switch the roller paper holder (fastened side) screws to the inner side screw holes and position the
edge of the roll paper holder (fastened side) to the central position of the reference b.
Position the Roll Paper Holder Edge with the Scale b
Supports 45mm paper width
See Fig. 3.6.2.2.E. for the roll paper holder (fastening side) setting position to handle paper widths
of 45 ±0.5. mm.
Position the edge of the roll paper holder (fastened side) onto the central position of the reference a
position.
Position the Roll Paper Holder Edge on the Scale a
Notes:
1. The default setting support 1 inch paper tubes and paper widths 82.5 mm.
2. If the setting position is incorrect, the roll paper will be supplied improperly to the mecha-
nism which in turn causes paper transport problems. Thus, it is should be properly ad-
justed.
TUP500 Series Product Specifications
F ig. 3.6.2.2.D .
F ig. 3.6.2.2.E .
3-20