Black Mark Specifications - Star Micronics TUP500 Series Product Specifications Manual

Notes:
1. Ex-factory default settings are for 72 mm.
2. Values relating to the left/right margins above are not guaranteed.
3. Operating the printer with the values designated by the asterisk cannot ensure the rec-
ommended left/right margins of more than 4 mm. The print region may be outside of the
paper width.
(11) Other Precautions: See below
1)
2)
3)
4)
3.3.2.

Black Mark Specifications

The following describes the recommended black mark specifications for printers that use the paper out detector
as the black mark detector.
Backside of Paper
B (mm)
Cutting
Position
C (mm)
(1) Black Mark Pitch (Dimension A)
Black mark pitch can be set to the following range.
CONFIGURA-
TION
TUP592
TUP542
TUP500 Series Product Specifications
The coloring side should be the outside portion of the roll paper.
Do not use inner wrapped rolls.
The trailing edge should not be folded.
Do not glue to fasten to roll paper and shaft core.
P rinting
D irectio n
Print Range
Print Surface
is Backside
F ig. 3 .3.2 . B la c k M ark S pecificatio ns
Black Mark Pitch (Dimen-
sion A)
75 to 300 mm
45 to 300 mm
25 ±2 (mm)
Min. 15 (mm)
3-13
A (mm)
5 ±1 (mm)