5 .3 . Error Specifications; Auto-Recovery Error; Recoverable Errors - Star Micronics TUP500 Series Product Specifications Manual

15.3 . Error Specifications

15.3.1. Auto-recovery Error

This error automatically cancels E errors by varying the status internally on the printer.
Error LED
LED1 (Green)
Head High Flashing Cycle
Temperature for 1.0 seconds
Stopped Printing

15.3.2. Recoverable Errors

This error cancels errors while maintaining the printer's status, by executing a determined error canceling operation.
Error LED
LED1
(Green)
NE Error ON
Cover Open Error ON
PE Error ON
BM Error ON
TUP500 Series Product Specifications
Cause of Error
LED2 (Red)
OFF Head Thermistor High Temperature (70ºC)
Cause of Error
LED2
(Red)
Flashing Cycle Low in paper
for 4.0 seconds
ON Cover Open
Flashing Cycle Paper Out Detection
for 1.0 seconds
Flashing Cycle Black Mark Paper Size Error
for 1.0 seconds (White detected over 400 mm long)
How to Cancel Error
Replace the paper
1. Remove paper in the presenter and in the printer.
2. Replace Paper
3-1) Manual Operation
3-1-1 Set the paper and close the cover.
3-1-2) Sw2 Push
3-2) Auto-loading Operation
3-2-1) Close the cover
3-2-2) Insert paper into the printer's paper supply inlet.
3-2-3) Auto-loading Operation Startup
4) Online Recovery Operation Execution
1. Open the cover, remove paper in the presenter and in the
printer.
2. Replace Paper
3-1) Manual Operation
3-1-1 Set the paper and close the cover.
3-1-2) Sw2 Push
3-2) Auto-loading Operation
3-2-1) Close the cover
3-2-2) Insert paper into the printer's paper supply inlet.
3-2-3) Auto-loading Operation Startup
4) Online Recovery Operation Execution
Replace Black Mark Paper
Readjust with Sensor Adjustment Mode
15-4
How to Cancel Error
Automatic recovery when temperature
drops (65ºC)