Vibration/Falling Shocks; Vibration Tests (When Packing); Drop Tests (When Packing); Impact Tests (When Not Packing) - Star Micronics TUP500 Series Product Specifications Manual

5.3. Vibration/Falling Shocks

Vibration Tests (When Packing)

5.3.1.
With the following testing conditions, must be no visual or operational problems externally or internally after ap-
plying vibration.
Vibration Direction
Vibration Frequency:
Sweep Time:
Vibration Acceleration Speed:
Printing Time
Packed Status
5.3.2.

Drop Tests (When Packing)

With the following testing conditions, must be no visual or operational problems externally or internally after ap-
plying vibration.
Height of Drop
Direction of Drop
Number of Drops
Packed Status
5.3.3.

Impact Tests (When Not Packing)

Must be no visual or operational problems externally or internally when not operating, after dropping.
Height of Drop
Direction of Drop
Number of Drops

5.4. Noise

Measured Rating: ANSI 1.29
TUP592-24
TUP542-24

5.5. Dust

There is no affect on operation in a normal office environment.

5.6. Installation Posture

Printer Setup Posture
Tolerance Range of Setup Posture
Notes:
1. The printer was designed to conditions for a horizontal layout. If the printer I used when
setup outside of the tolerance range, paper conveyance problems will occur and paper
jams will occur.
TUP500 Series Product Specifications
Logarithmic Frequency Sweep Rate:
80cm
1 angle; 3 corners; 6 surfaces
Once each time (Total of 10 drops)
Minimum Packing Status
5cm
4 Sides, Side Support
1 time each
Approx. 58 dB
Approx. 58 dB
Horizontal layout
XYZ
7Hz to 100Hz
1.5 G (Constant)
One hour (Total 3 hours)
Minimum Packing Status
±3°
5-4
Reciprocal at 5 minutes