Star Micronics TUP500 Series Product Specifications Manual page 119

When Power is ON
Operating Mode
Self-test Print Push
Hex Dump
Sensor Adjustment Mode
PE/BM Sensor
Sensor Adjustment Mode
NE Sensor
Sensor Adjustment Mode Push
Presenter Sensor 1
When Online
Operating Operation
SW1 SW2
Push -- Paper Feed (*1)
Push Push Executes printer reset.
(2 Sec.) (2 Sec.)
(*1) Paper Feed
Presenter Status Black Mark Function
Non-contact Invalid
Valid
Contact Invalid
Valid
When errors occur
Operating Operation
SW1 SW2
-- Push Error cancel operation
Push -- Paper is discharged from printer.
Push Push Executes printer reset.
(2 Secs.) (2 Secs.)
TUP500 Series Product Specifications
Mode Entering Conditions
SW1 SW2 Cover
1
-- -- *
-- Push -- *
-- -- Closed *
-- Push Closed *
-- Closed *
Paper Feed Specifications
Paper is fed while SW1 is pressed.
BM detection operation + full cut
Paper Feed + Full Cut + Presenter Paper Discharge
BM Detection + Full Cut + Presenter Paper Discharge
DIPSW1 Setting
2 3 4 5 6
* * ON * *
* * ON * *
* * OFF ON *
* * OFF ON *
* * OFF ON *
Memo
After pushing SW2, input SW1.
Memo
The predetermined error cancelation operation was performed.
If there is no paper and printing has stopped because of the error, it is possible to discharge
the paper remaining in the printer without opening the cover.
However, this function can damage the print head so do not over use it.
After pushing SW2, push SW1.
15-2
Operation
7 8 9 10
* * * * Self-print → Printer Reset
* * * * Enters Hex Dump Mode
* * * * LED Flashes, and printer
enters the sensor adjustment
mode
* * * * LED Flashes, and printer
enters the sensor adjustment
mode
* * * * With LED flashing:
Enters Sensor Adjustment
Mode