Power Up And Test - ETC Echoflex Dual Tech Installation Manual

Switch-mount occupancy sensor
Table of Contents

Advertisement

Echoflex Installation Guide
Switch-mount Occupancy Sensor
Install the Wall Plate
The wall plate is secured to the station with built-in magnets.
Note:
misaligned in the mounting box, the wall plate will not attach properly.
Loosen the screws that secure the station to the box, adjust each station
to improve the alignment, secure the screws, then retry wall plate
installation.

Power Up and Test

Power Up
All EchoConnect terminations in the system must be made before applying
power to the system and sensor. When the sensor is powered up, the PIR and
acoustic detection LEDs illuminate for one minute for calibration and warm-
up, and then return to normal operation according to the configuration.
Both the PIR and acoustic detection features of the sensor will automatically
adjust sensitivity threshold to eliminate nuisance tripping. During this time,
sensor configuration is not allowed and no events are triggered.
Dual Technology Detection
When both PIR and acoustic detection are used, the following logic is
followed:
When the space is vacant, PIR detection and manual control can switch
the state to occupied.
When the space is occupied, PIR, acoustic detection, and manual
control can reset the vacancy timeout.
When occupancy in the space has only been triggered by acoustic
detection for 60 minutes, acoustic detection is disabled until the next
PIR detection event.
Dual Tech Switch-mount Occupancy Sensor
1.
2.
3.
4.
When installing a multi-gang wall plate and the stations are
Align the top of the wall plate to the station
and angle the bottom approximately 20
degrees.
Hook the top of the wall plate to the tabs
located on the station electronics assembly.
To ensure the wall plate is hooked properly on
the top hook, wiggle it slightly side to side.
Swing the bottom of the wall plate down until
the magnets engage.
If the wall plate does not fully attach
automatically, wiggle the bottom of the plate
until all of the magnets are seated properly to
the station and the plate is secure.
Page 9 of 20
Echoflex Solutions, Inc.

Advertisement

Table of Contents
loading

Table of Contents