Test Operating Modes; Walk Test Mode - ETC echoflex MOS-MT Series Installation Manual

Wireless ceiling mount iot sensor
Table of Contents

Advertisement

this guide. Also, a GP teach-in process is required before its data messages
can be properly interpreted. See the programing guide (URL on page 8) for
more information

Test Operating Modes

The following tests can be selected when in test mode:
• Light Level Test

• Walk Test Mode,

• PIR Audio / EEP configuration mode
• Occupancy LED indication enable/disable
i
Note:
Light Level Test: This test provides visual feedback of the immediate energy
produced by the solar panels.
1. To enter Light Level Test mode, press and hold the teach button until
the green LED begins to blink (about 6 seconds).
2. Press and hold the teach button again until the green LED stops
blinking, about 6 seconds. The green LED will start blinking faster in
accordance to the light level it is detecting, see table below.
Blinks Lux / Foot candles Time to Fully Charge
0
1
2
3
80-160 / 8-16
4
160-320 / 16-32
5
The time to fully charge is based on the storage capacitor charging from a
non-operational condition. Discharge time indicates how long a fully charged
sensor will operate in the dark. The test will repeat every 2 seconds and run
for a duration of 100 seconds. You may quit the test at any time by pressing
the teach button for 6 seconds.
Walk Test Mode
Walk test mode allows the installer to verify areas that are within range of the
motion sensor.
1. To enter walk test mode, press and hold the teach button until the
green LED begins to blink (about 6 seconds).
2. A quick press and release of the button at this point will allow you to
select between test modes. Pressing and releasing the teach button
scrolls through the LED indicators. When the red LED is blinking, go to
step 3.
3. Press and hold the teach button again for 6 seconds to select walk
test.
There a 3 LED colors, green, blue and red. Some units may have an
amber LED in place of the blue LED. For clarity this guide assumes a
LED. Blue(A) will be used when discussing this colored LED..
blue
Light Level Test Indication
0 / 0
20-40 / 2-4
40-80 / 4-8
320 + / 32+
below operating level
operational
48 hours
24 hours
12 hours
6 hours
Discharge Time
n/a
n/a
100 hours
150 hours
200 hours
225 hours
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Echoflex mos-mt a seriesEchoflex mos-mt b series

Table of Contents