Table of Contents
Advertisement
Echoflex Installation Guide
Switch-mount Occupancy Sensor
2.
Remove the button lens.
3.
Once the lens is removed, remove the existing
legend and insert a custom legend.
4.
Replace the lens onto the button by aligning the
grooves of the lens to the button, then sliding the
lends in place starting at the hinge. Slide the lens
until it covers the entire button and clicks into
place.
5.
Replace the bezel to the station electronics when
all legends and lenses are in place.
Install the Station
Receptacle spacers are provided for use in flush mount applications to help
align the station and cover flush against the wall.
1.
Insert the station electronics
and wiring into the switch
box. To install multiple
stations (multi-gang), insert
the station electronics into
the box from the right to the
left side for the best
alignment and fit. The
alignment bracket will slightly overlap the station to the right when
properly installed.
2.
Use spacers as needed to provide a flush mounted station.
3.
Secure each station electronics in place using the two screws provided.
If using spacers, insert the screws through the spacers as well.
CAUTION:
do not over tighten the screws. If screws are over tightened, button
activation can be negatively impacted.
Dual Tech Switch-mount Occupancy Sensor
Using the pads of your thumb, press on the lens
•
and slide the lens left, toward the hinge points.
a.
Fold the spacer in a zig-zag fashion and press the stack together
to achieve the thickness needed to fill the gap between the
station, wall surface, and the switch box.
b.
Cut off and discard the excess.
c.
Place the stack between the station electronics and the flush
mounted switch box.
To improve successful station and wall plate installation,
Page 8 of 20
Echoflex Solutions, Inc.
Advertisement
Table of Contents
