Advertisement
Double
green: PIR sensitivity
Double
amber: audio sensitivity (DT only)
Double
red: occupancy sensor timer (DT only)
Light Level Test
Every sensor except the OWS uses solar cells for power. The light level test shows how much light exposure the solar
cells have so you can ensure you are installing the sensor in a position where it will successfully charge.
Steps:
1. To enter the main test/config menu, press and hold TEACH/TEST button 6 seconds until:
a. occ/vac sensors except OWS:
b. light sensors:
2. Release button so:
a. occ/vac sensors except OWS:
b. light sensors:
3. Press and hold again for 6 seconds until the LED de-illuminates
4. Release button,
a. patterns will vary by sensor, reference table in sensor's installation guide as needed
guides
at the end of article)
Range Confirmation Test
One of the most important factors to keep in mind when installing Echoflex equipment is positioning for the strongest
signal strength between the wireless radios to ensure proper communication. The range confirmation test shows the
signal strength of telegrams passing between devices you are testing to assist with setup.
NOTE: Only one output controller should be linked to the sensor for this test, and no signal
repeaters should be enabled.
1. To enter the main test/config menu, press and hold TEACH/TEST button 6 seconds until:
a. occ/vac sensors except OWS:
b. OWS:
red/amber/green
c. light sensors:
2. Release button so:
a. occ/vac sensors except OWS:
b. OWS:
red/amber/green
https://support.etcconnect.com/ETC/Architectural/Aero_and_EchoFlex/Aero_and_Echoflex_Sensors/Guide_to_Test_and_Co...
green
green
LED blinks (slowly)
green
green
LED blinks (quickly)
green
LED will blink pattern to indicate light level
green
LEDs blink together
green
LED blinks (slowly)
green
LEDs blink together
LED illuminates solid
LED illuminates solid
LED illuminates solid
LED illuminates solid
(full list of links to
Updated: Fri, 17 Sep 2021 16:18:01 GMT
Powered by
3
Advertisement
