Page 1
Guide to Test and Configuration Modes Menu for Echoflex Sensors Explanation Each type of Echoflex Sensor supports various test or configuration modes, utilizing its TEACH/TEST button to navigate these modes via taps or press and holds and LEDs to indicate statuses.
(Red → Amber Blue → Green → → etc.) Press and hold 6 seconds ? Specific Test/Config Menu Follow steps for specific test/config LED Indicators • Occupancy/vacancy and photo sensors have a different set of LEDs ◦ Occ/vac: red/AMBER/green ◦ Photo: red/BLUE/green •...
Range Confirmation Test One of the most important factors to keep in mind when installing Echoflex equipment is positioning for the strongest signal strength between the wireless radios to ensure proper communication. The range confirmation test shows the signal strength of telegrams passing between devices you are testing to assist with setup.
Page 4
If unit is dual tech with audio enabled, green LED will also blink when it detects audio Sensor Settings Mode There are 3 possible settings for each occupancy/vacancy sensors: https://support.etcconnect.com/ETC/Architectural/Aero_and_EchoFlex/Aero_and_Echoflex_Sensors/Guide_to_Test_and_Co… Updated: Fri, 17 Sep 2021 16:18:01 GMT Powered by...
Page 5
Once you enter the sensor setting mode menu, you will notice double blinks instead of single blinks to indicate mode selection. For more information on the occupancy sensor timer parameter and how it functions alongside the occupancy timer of Echoflex output controllers, see this article: Failed Vacancy Operation with Echoflex Dual Tech Sensors 1.
1. To enter the main test/config menu, press and hold TEACH/TEST button 6 seconds until the green LED blinks slowly 2. Release button so the green LED blinks faster https://support.etcconnect.com/ETC/Architectural/Aero_and_EchoFlex/Aero_and_Echoflex_Sensors/Guide_to_Test_and_Co… Updated: Fri, 17 Sep 2021 16:18:01 GMT Powered by...