Section 6: Operating Procedures; Assembly - Taylor 0738 Operator's Manual

Section 6
This machine stores mix in a hopper. It has a
2.1 qt. (2.0 L) capacity barrel with a single-
spout door.
We begin our instructions at the point where we
enter the store in the morning and find the parts
disassembled and laid out to air dry from the
previous night's cleaning. These opening
procedures will show you how to assemble these
parts into the freezer, sanitize them, and prime the
freezer with fresh mix in preparation to serve your
first portion. If you are disassembling the machine
for the first time or need information to get to this
staring point in our instructions, see
"Disassembly" on page
6-11

Assembly

Note: When lubricating parts, use an approved
food grade lubricant (example: Taylor Lube).
MAKE SURE THE MACHINE IS
DISCONNECTED! Failure to follow this
instruction may result in severe personal injury
from hazardous moving parts.
Beater Assembly
1. Attach the scraper blade to the beater
assembly at the locations as indicated.
Repeat this step for the others scraper
blades.
2. Insert the beater auger on the beater body;
Make sure the lip of the auger is inserted in
the slot of the beater.
Operating Procedures
and start there.
Model 0738
Operating Procedures
3. Lightly lubricate both sides of the beater
driveshaft seal. Slide this seal up to the stop.
Do not lubricate the square end.
4. Holding the beater securely, slide the beater
assembly into the freezer cylinder while lightly
compressing the scraper blades. Slide the
beater into the barrel and engage the square
end firmly into the drive coupling.
6
6-1