Section 5: User Interface; Control Switch (Item 1); Push-Button Switch (Item 2); Display Light Switch (Item 3) - Taylor 432 Operator's Manual

Section 5
4
1
Item
1 Switch- Toggle - 3 PDT
2 Switch- Push Button - SPST
3 Switch- Toggle- SPST - 3/4 HP/250 V
4 Light- Amber- Rect. - 12 VDC - MIX OUT
5 Light- Amber- Rect. - 12 VDC - ADD MIX
6 Viscosity Adjustment
The following chart identifies the symbol definitions used
on the operator switches.
= ON/AUTO
= OFF
= WASH
User Interface
2
Description
3
Figure 5-1

Control Switch (Item 1)

The center position is OFF. The left position is WASH,
which activates only the beater motor. The right position
is AUTO, which activates the beater motor and the
refrigeration system.

Push-Button Switch (Item 2)

If an overload condition occurs, the freezer will
automatically stop operating. To properly reset the
freezer, place the toggle switch in the OFF position. Wait
two or three minutes, then press the push-button switch.
Place the power switch in the WASH position and
observe the freezer's performance. Place the power
switch in the AUTO position.
Note: If the freezer is unplugged from the wall
receptacle, it will be necessary to press the push-button
switch for the freezer to operate once power is
re-established.

Display Light Switch (Item 3)

The display light switch is located under the control
channel. The left position is OFF. The right position is ON
and activates the display light.
Model 432
User Interface
5
6
5

5-1