Softech™ Control Operation - Taylor Horizon 8752 Operator's Manual

USER INTERFACE
Power Switch
When placed in the on position, the power switch allows
Softech™ control panel operation.
Indicator Lights
MIX LOW—When the MIX LOW light begins to flash, the
mix tank has a low supply of mix and should be refilled as
soon as possible.
MIX OUT—When the MIX OUT light begins to flash, the
mix tank has been almost completely exhausted and has
an insufficient supply of mix to operate the freezer. At this
time, the Standby and Auto modes are locked out and the
freezer shuts down. To initiate the refrigeration system,
add mix to the tank and press the AUTO button. The
freezer automatically begins operation.
RESET Button
The reset button is located in the decorative plate above
the Softech™ controls. The reset protects the beater
motor from an overload condition. Should an overload
5
occur, the reset mechanism will trip.
To properly reset the freezer, press the AUTO button to
cancel the cycle. Turn the power switch to the off
position. Press the RESET button firmly. Turn the power
switch to the ON position. Press the AUTO button to
resume normal operation. (For the Model 8756, press the
AUTO button on both sides to resume normal operation.)
If the freezer shuts down again, contact your service
technician.
5-2
Softech™ Control Operation
MIX REF
When the MIX REF button is pressed, the light comes on,
indicating the mix cabinet refrigeration system is
operating. (For the Model 8756, there are two touch-tone
panels, one for each freezing cylinder. The mix
refrigeration system is controlled by the MIX REF button
found on the left panel. By pressing the AUTO button on
either side of the freezer, the Mix Ref function is
automatically turned on.) The Mix Ref function cannot be
canceled unless the Auto or Standby mode is canceled
first.
STANDBY
During long no sale periods, the machine can be placed
into the Standby mode. This maintains product
temperatures in the freezing cylinder to approximately
°
35 F to 40
and product breakdown.
When the STANDBY button is pressed, the light comes
on, indicating the Cylinder Temperature Retention (CTR)
System has been activated. In the Standby mode, the
Wash, Pump, and Auto functions are automatically
canceled. The Mix Ref function is automatically locked in
to maintain the mix in the cabinet.
To resume normal operation, press the STANDBY button
to cancel the cycle, and then press the AUTO button.
When the machine cycles off, the product in the freezing
cylinder will be at serving viscosity.
WASH
When the WASH button is pressed, the light comes on,
indicating beater motor operation. The STANDBY button
or Auto modes must be canceled first to activate the
Wash mode.
Models 8752 and 8756 with Horizon® Pump
° ° °
F (1.7 C to 4.4 C) to prevent overbeating
User Interface