Operation; Operation Procedure; Switching The Monitor On - Teledyne GT Series User Manual

Hide thumbs Also See for GT Series:

Table of Contents

GT SERIES

1 INSTRUMENT, 7 APPLICATIONS

3. Operation

Check the following before use:

• The monitor is clean and in good condition.

• The hydrophobic filter is clean and in good condition.

• The clear probe filter bulb is screwed tightly and in good condition.

• The sample line and any other accessories used are in good condition.

• The batteries are in good condition, fully charged and fitted correctly.

• The battery indication provides sufficient capacity for the application.

• The monitor is within your calibration period.

• The flow fault and filter check are successful.

• All applicable ranges are operational.

• There are no fault indications.

• Attach optional accessories, as required.

WARNING: ALWAYS SWITCH THE MONITOR ON IN FRESH AIR.

• Press and hold the RH button

• A 30-second warm-up routine begins (a countdown timer appears).

• The Power ON LED and the display backlight illuminates. Both remain ON during warm-

up.

Figure 2: Switching the Monitor On

for one second.

67112

Revision 10

Table of Contents