Teledyne GT Series User Manual page 25

1. To highlight the required option, press the UP
2. To accept the highlighted option, press and hold OK
Note: Barhole mode of the monitor can be configured to have timed, non-timed or
both.
4.3.3.1. Timed Sampling
If timed sampling is selected, the user can set the barhole sample time as indicated in
Timed Mode (time selection).
1. To change the sample time, press the UP
and 300 seconds).
2. Press and hold OK
Note: If the monitor configuration does not allow user to change this sample time,
the pre-set value is displayed.
3. The monitor performs an initial purge, as shown in
The purge can be stopped when the live readings reach zero; press and hold STOP
67112
Revision 10
Figure 23: Barhole Sampling Types
Figure 24: Timed Mode (time selection)
to accept.
Figure 25: Purge
1 INSTRUMENT, 7 APPLICATIONS
or DOWN buttons.
button.
or DOWN buttons (alterable between 10
Figure 25: Purge.
GT SERIES
Figure 24:
button.
19