Table of Contents
Advertisement
• When warm-up is complete, the backlight automatically switches OFF.
• The Fault LED illuminates during the warm-up flow fault test.
Refer to
Figure 2: Switching the Monitor On
3.3. Monitor Identification
During warm-up, the serial number, software version and battery status information are listed, as
shown in
Figure 3: Monitor
3.4. Filter Check/Flow Fault Test
By default, this check is performed daily. This option can be enabled or disabled by the user.
3.4.1 Filter Check
• Press YES to continue.
• Press NO to enter the Switch OFF sequence.
3.4.2 Flow Fault Test
When Flow Fault Test screen is displayed (as shown in
options:
1. Perform the Flow Fault Test.
2. Press SKIP to continue warm-up without performing the test.
3. Press OFF to initiate the Switch OFF sequence.
67112
Revision 10
for more details.
ID.
Figure 3: Monitor ID
Figure 4: Filter Check
1 INSTRUMENT, 7 APPLICATIONS
Figure 5: Flow Fault
Test), there are three
GT SERIES
7
Advertisement
Table of Contents
