Utility Led Commands; Led Status Request Command - Andover Controls Infinity Manual

Technical Manuals Online! - http://www.tech-man.com

Utility LED Commands

The following LED commands are also available:
Turns ALL of the FSCS LEDs OFF.
(CLR)
(TST) Turns ALL of the FSCS LEDs ON for
approximately 3 seconds, then resets them all to
their previous state.

LED Status Request Command

The CX9200 can request the status of any LED using the following
command:
Where nnn is the LED number
($nnn)
The FSCS would respond with one of the three following messages:
LED nnn is ON
(Xnnn)
(Znnn) LED nnn is OFF
(Fnnn) LED nnn is FLASHING
C-4
FSCS Protocol
Infinity Smoke Control Guide
TOC