Clamp End Spacers - Optional - Landoll Brillion WFPD38-52 Operator's Manual

MAINTENANCE

Clamp End Spacers - Optional

The Clamp End Spacer Kits are used to eliminate space
between the Axle Clamp and the Wheel Stop.
IMPORTANT
Unfold and lower machine prior to performing any steps.
4-8
Figure 4-6: Clamp End Spacer Kit, 1 of 2 - Optional
Kit Part Number 201442 - 3/4" Axle Spacer
Kit Part Number 201443 - 1/2" Axle Spacer
Installation is the same for either kit.
1. Place the two Axle Spacers between the Axle Clamp
and the Wheel Stop.
2. Insert two 3/8-16 x 1-3/4 Bolts through the Axle
Spacers and secure with 3/8-16 Locknuts.
Refer to the Torque Table for proper bolt torque values.
Note the different torque requirement for Bolts with
Locknuts. page 4-1.
F-661R4