Table of Contents
Advertisement
OPERATION
Reflectors and SMV Sign
Reflectors and a slow moving vehicle sign (SMV) are
required if the Wing Float Pulverizer is transported on a
public road. Check with local laws/ordinances.
NOTICE
When Transporting on Roadways, Obey all
Applicable Laws and Regulations.
Figure 3-8: SMV Sign
Scraper Adjustment
The roller scraper is designed to keep the roller from
building up with moist soil during operation. Adjustment
of the scraper will be necessary as the roller and/or the
scraper wears. Adjustment is done by loosening the
3/8-16 Flange Nuts on the U-bolts and sliding the blade
side to side or up and down as needed. The blade should
be kept 1/4" from the roller wheel.
The Scrapers for the 20" wheels are reversible.
NOTE
Scraper Adjustment should be done with the rollers
lowered and on level ground.
3-8
Settings for Loup Acre Meters
The battery operated acre counter operates in one of two
modes. In sleep mode, the display is blank, and the
counter is accumulating acres. Sleep mode will be
entered if a button is not pressed for 20 seconds. In entry
mode, the display is on, and the operator can enter
values. To get into entry mode, press the
button. If you continue to press the
acre counter will cycle through the functions that it can
perform. The LEDs above the display indicate which
function is selected.
The available functions are:
Field Acres, Total Acres, Pulses per 400 ft, Width,
Password and Low Battery
Field Acres
*
Press the
/FUNC button until the "FIELD" LED is lit.
The digits indicate the acres covered since the field acre
counter was cleared.
To clear the field acre count, press the UP and DOWN
buttons simultaneously for two seconds. If a password
has been entered, you will not be able to clear the total
acre count. Field acres will count in tenths of an acre up
to 9999.9 acres.
Total Acres
*
Press the
/FUNC button until the "FIELD" and "TOTAL"
LEDs are lit. The digits indicate the acres covered since
the total acre counter was cleared.
To clear the total acre count, press and hold the UP and
DOWN buttons for two seconds. If a password has been
entered, you will not be able to clear the total acre count.
Total acres will count from.1 to 99999 acres.
Pulses Per 400 Feet
*
Press the
/FUNC button until the "PULSES" LED is lit.
The number in the display indicates how many pulses are
generated for every 400 feet driven. There are two
methods to enter the pulses per 400 feet:
If you know the number, select it using the UP and
DOWN buttons. When you press the
the Acre Counter will accept the number in the display as
the new pulses per 400 feet. See Table 3-1.
If you do not know the pulses per mile, press and hold the
UP and DOWN buttons until the "0000" appears in the
display. The "PULSES" LED will blink. The acre counter
is now counting shaft rotations. Enter the cab and drive
*
400 feet. Press the
/FUNC button to wake up the acre
counter. The "PULSES" LED will again blink. The number
displayed is the pulses per 400 feet. Press the
button to accept the setting. The "PULSES" LED will stop
blinking and remain on.
*
/FUNC
*
/FUNC button, the
*
/FUNC button,
*
/FUNC
F-661R4
Advertisement
Table of Contents
