V-Wheel Center Scrapers - Optional - Landoll Brillion WFPD38-52 Operator's Manual

ASSEMBLY

V-Wheel Center Scrapers - Optional

With the Rollers on level ground, attach Scraper Brackets
to The Front Frame Tube with 5/8-11 U-Bolts and
Flanged Locknuts. Tighten Flanged Locknuts only
enough so Brackets can be adjusted accordingly on the
Frame Tube. Center Scraper Bars are pre-assembled
with Scrapers attached (spaced approximately 6 inches
2-28
apart). Loosen Three Scraper U-Bolts on each Scraper
Bar where the Scraper Bar will attach to the Scraper
Brackets. See Figure 2-24. Place Scraper Bar against
the Scraper Brackets Tab. Secure by sliding the
loosened 1/2-13 U-Bolts over each Scraper Bracket Tab
and tightening the Flanged Locknuts. Tighten all Scraper
Bracket Hardware.
Figure 2-24: V-Wheel Center Scrapers
F-661R4