Rep 4.8 Exit Roll And Bushings - Xerox B205 Service Manual

4. Remove the Output Tray Full Sensor,
a. Disconnect the Sensor connector.
b. Unlatch and remove the Output Tray Sensor.
Figure 2 Output Tray Full Sensor (Top Right View)
Replacement
NOTE: Tapered Plastic Screws and Round Machine Screws are used to hold the Fuser to the
frame. Make sure that the Plastic Screws go into plastic components and Machine Screws go
into the metal frame.
The replacement is the reverse of the removal procedure.
Initial Release
Xerox® B205/B215 Multifunction Printer Service Manual
Figure 2:
Output Tray Full Sensor

REP 4.8 Exit Roll and Bushings

Parts List on PL 4.3
Removal
1. Switch off the printer, then disconnect the power cord.
2. Remove the Middle Cover,
3. Remove the Exit Roll and Bushings,
a. Remove the Drive Gear, then release the latch.
b. Remove two Bushings, then release the latch and rotate the bushing.
c. Remove the Exit Roll.
Bushings
Figure 1 Exit Roll and Bushing (Top View)
Replacement
The replacement is the reverse of the removal procedure.
July 2019
4-25
REP 2.5.
Figure 1.
Exit Roll
Drive Gear
Repairs / Adjustments
REP 4.7, REP 4.8