Gp 3 Machine Firmware Version - Xerox B205 Service Manual

Procedure (B205)
From the Control Panel:
1. Press the <Information> button
2. Use the up/down arrows to scroll to <Info Pages>, then press the <OK> button.
3. Scroll to <Usage Counter> then press the <OK> button to print a Usage Counter report.
or
1. Enter Diagnostics Mode, select <Diagnostics> then press the <OK> button
2. Use the up/down arrows to select <Report>, then press <OK>.
3. Use the up/down arrows to select <Usage Counter>, then press <OK>, then <OK> again
to print a Usage Counter report.
General Procedures / Information
GP 2, GP 3

GP 3 Machine Firmware Version

Purpose
Use this procedure to check the firmware version of the machine.
Procedure (B215)
1. At the Home screen touch [Device > About > General],
The Firmware Version is listed as [Software Version] on the screen.
Figure 1 General information screen entry
NOTE: The Firmware version is also printed in the Configuration Report under Device
Setup labeled, System Software Version. Refer to
Procedure (B205)
From the Control Panel:
1. Press the <Information> button.
2. Use the up/down arrows to scroll to Info Pages, then press the <OK> button.
3. Use the up/down arrows to scroll to Configuration then press the <OK> button to print a
configuration report.
4. See [System Software Version] under <Device Setup> heading.
or:
1. Enter Diagnostics Mode, GP
2. Use the up/down arrows to select <Report> then press <OK>.
3. Use the up/down arrows to select the desired report to print, press <OK>, then <OK>
again to print the report.
The firmware version is listed under Device Setup > System.
July 2019
6-18
Figure 1.
GP 6, Machine Reports.
1:
Xerox® B205/B215 Multifunction Printer Service Manual
Initial Release