Xerox B205 Service Manual page 48

17-130 Login Error
The machine can not login to the designated server.
• Request the customer verify connectivity and network setup settings are correct for the
customer network.
17-140 Access Denied
A permissions error occurred.
• Request the customer verify the user has correct permissions to perform the task
requested of the machine.
17-150 Lock Exists
• The *.lck directory already exists.
17-200 Network Cable is Disconnected
• Ensure the network cable is connected.
17-510 Operation Error
An error occurred when sending the image file.
• Request the customer verify the image file is of the correct file type for the requested task.
• If the image file is on a USB drive, remove then reinsert the USB drive into the machine,
then run the send job again.
• If the fault persists, request the customer change USB drives to a known good USB drive,
then run the send job again.
17-600 Filename is Too Long
The name of the file to be sent is longer than the destination systems limits.
• Shorten the file name.
17-610 Scan File Exists
The file name already exists on the destination server.
• Change the file name.
Initial Release
Xerox® B205/B215 Multifunction Printer Service Manual
17-310 Communication Error (Main PWB to Wireless PWB)
RAP
BSD-ON:BSD 1
Control Panel Fault Displayed
B205: Network Problem: Wi-Fi Connection
B215: Network Communication Error
The machine software has detected a communication error between the Main PWB and the
Wireless PWB.
Initial Actions
• Switch off, then switch on the machine
• Check machine network and data configuration settings.
Do not perform repair activities with the power on or electrical power supplied to the
machine. The machine could activate and cause serious personal injury when the power
is on or electrical power is supplied.
DANGER: Ne pas effectuer de dépannage avec le contact principal activé ou avec l'ali-
mentation électrique appliquée à la machine: celle-ci pourrait démarrer et causer de
graves blessures.
AVVERTENZA: Non effettuare alcuna riparazione con la macchina accesa o con l'ali-
mentazione elettrica inserita. La macchina potrebbe avviarsi all'improvviso e causare
gravi ferite.
VORSICHT: Es dürfen keine Reparaturarbeiten durchgeführt werden, solange das Gerät
eingeschalten oder mit der Stromquelle verbunden ist. Das Gerät kann u.U in den Aktiv-
Zustand übergehen und somit erhebliche körperliche Schäden verursachen.
AVISO: No realice reparaciones con la máquina encendida o conectada a la corriente.
La máquina podría activarse y ocasionar daños personales graves.
Procedure
1. Ensure that the connectors are fully seated between the Main PWB and the Wireless
PWB, CN1.
2. If the fault persists, install new components in the following order:
• Flat Cable, PL 4.1 Item
• WiFi PWB, PL 1.1 Item
• Main PWB, PL 1.1 Item
July 2019
17-110, 17-130, 17-140, 17-150, 17-200, 17-510, 17-
2-27
WARNING
1.
10.
4.
Status Indicator RAPs