Xerox B205 Service Manual page 101

25. Remove the Registration Roll from the Paper Path Frame,
NOTE: Note the location of the bushing in the frame for reinstallation.
Bushing
Figure 18 Registration Roll Removal
26. Remove the bushing and e-ring from the Registration Roll,
E-ring
Bushing
Figure 19 Registration Roll
Repairs / Adjustments
REP 4.9
Figure 18.
Registration Roll
Figure 19.
July 2019
4-34
Replacement
NOTE: Tapered plastic screws and round machine screws are used to hold the parts to the
frame. make sure that the plastic screws go into plastic components and machine screws go
into the metal frame.
The replacement is the reverse of the removal procedure.
NOTE: The frame is flexible and can be bowed out if the screws are not tightened in the cor-
rect order. Reinstall the frame as follows so it seats flush against the printer's internal modules.
1. After aligning the left and right frames together with the inside modules; install, but do not
tighten, the three Paper Path Frame screws on the Right,
15.
2. On the bottom of the printer, refer to,
a. Install the ground screw.
b. Connect the Printer Drive Motor Connector.
3. Tighten the Paper Path Frame screws installed in Step 1.
4. Continue with the parts replacement:
a. When installing the Paper Feed Sensor Actuator make sure the spring is seated in
the frame cutout, refer to, Figure
b. Refer to, Figure 20, for installation of the Feed and Registration Drive Gears and
Snap Ring.
Snap Ring
Figure 20 Feed and Registration Drive Gears
Xerox® B205/B215 Multifunction Printer Service Manual
Figure 14, and three Left,
Figure 8:
7.
Initial Release
Figure