7.
Remove the following parts,
Figure
a.
Remove the Drive Gears.
b.
Remove the snap ring, then remove the Feed Clutch Bushing.
c.
Release the latch and rotate the bushing, the remove the Feed Shaft Bushings.
d.
Remove the screw of the Feed Assembly.
Clutch Bushing
Figure 5 Feeder Drives
Repairs / Adjustments
REP 4.13
5:
Drive Gears
Screw
Feed Shaft Bushings
8.
Remove two screws from the bottom of the Feed Assembly,
Figure 6 Feeder Assembly Bottom Screws (Bottom View)
The brackets holding the registration pinch rolls and guide are spring loaded. Maintain light
pressure on the brackets when removing them to avoid damaging parts or personal injury.
9.
Remove two screws, then remove the Registration Pinch Rolls and Paper Guide Brackets,
Figure
7.
Figure 7 Registration Pinch Rolls and Paper Guide Brackets
July 2019
4-42
Figure
6.
Screws
CAUTION
Screws
Xerox® B205/B215 Multifunction Printer Service Manual
Initial Release