Xerox B205 Service Manual page 116

Replacement
NOTE: Tapered plastic screws and round machine screws are used to hold the cover to the
frame. Make sure that the plastic screws go into plastic components and machine screws go
into the metal frame.
1. Install the new Drive Motor.
NOTE: The Frame is flexible and can be bowed out if the screws are not tightened in the
correct order.
Reinstall the Frame as follows so it seats flush against the printer's internal modules.
2. Align the Frame on to the internal modules and shafts.
NOTE: Do Not fully tighten the screws in Step 3 until instructed.
3. Install, but do not tighten, the following module screws,
a. The Exit Sensor Plate screws (2).
b. The Front Paper Path Module screws (3).
Step 5c
Step 3a
Figure 7 Frame Screw Installation
Initial Release
Xerox® B205/B215 Multifunction Printer Service Manual
Figure 7:
Step 5b
Step 5e
Step 3b
4. On the bottom of the Printer, install the ground clip with the screw, then connect the Drive
Motor connector, Figure 7.
July 2019
4-49
Repairs / Adjustments
REP 4.15