Xerox B205 Service Manual page 40

09-800 Incompatible Toner Cartridge RAP
Control Panel Fault Displayed
B205: Invalid Print Cart.
B215: Incompatible Toner Cartridge has been Detected
The Toner Cartridge is not compatible with the printer.
Procedure
1. Press the Information button on the Control Panel, then select the menu items listed
below to print the Supplies Information Report.
• WorkCentre B205: [Info Pages, Supplies Info].
• WorkCentre B215: [Machine Status, Info Pages, Supplies Info].
2. Check the toner cartridge information. Install a new Toner Cartridge if is not a genuine
Xerox® cartridge.
Initial Release
Xerox® B205/B215 Multifunction Printer Service Manual
10-100 Fuser Temperature (Open) RAP
BSD-ON:BSD 1
Control Panel Fault Displayed
B205: Open Fuser error
B215: Fuser Error
During operation, the temperature of the Fuser temperature does not increase.
Do not handle the fuser components until they have cooled. Some fuser components
operate at hot temperatures and can produce serious personal injury if touched.
DANGER: Ne pas manipuler les éléments du four avant de les laisser refroidir. Certains
éléments du four fonctionnent à des températures très élevées et peuvent causer de
graves blessures s'ils sont touchés.
AVVERTENZA: Non maneggiare i componenti del fusore finché non sono raffreddati.
Alcuni di questi componenti funzionano ad alte temperature e possono provocare gravi
ferite se vengono toccati.
VORSICHT: Die Fixieranlage sollte erst gehandhabt werden, wenn diese genügend
abgekühlt ist. Einige Teile der Fixieranlage erzeugen übermäßige Hitze und führen bei
der Berührung zu schweren Verbrennungen.
AVISO: No manipule los componentes del fusor antes de que se enfríen. Algunos de los
componentes del fusor funcionan a altas temperaturas y pueden ocasionar daños per-
sonales graves si se los toca.
Do not perform repair activities with the power on or electrical power supplied to the
machine. The machine could activate and cause serious personal injury when the power
is on or electrical power is supplied.
DANGER: Ne pas effectuer de dépannage avec le contact principal activé ou avec l'ali-
mentation électrique appliquée à la machine: celle-ci pourrait démarrer et causer de
graves blessures.
AVVERTENZA: Non effettuare alcuna riparazione con la macchina accesa o con l'ali-
mentazione elettrica inserita. La macchina potrebbe avviarsi all'improvviso e causare
gravi ferite.
VORSICHT: Es dürfen keine Reparaturarbeiten durchgeführt werden, solange das Gerät
eingeschalten oder mit der Stromquelle verbunden ist. Das Gerät kann u.U in den Aktiv-
Zustand übergehen und somit erhebliche körperliche Schäden verursachen.
AVISO: No realice reparaciones con la máquina encendida o conectada a la corriente.
La máquina podría activarse y ocasionar daños personales graves.
Procedure
Switch off the machine, then verify the Fuser connection is fully seated. The Fuser connec-
tions are OK.
Y N
Firmly reconnect the Fuser assembly, then switch on the machine.
Check for +3.3 VDC to the Thermistor on the Main PWB. The voltage is present.
July 2019
2-19
WARNING
WARNING
Status Indicator RAPs
09-800 , 10-100