Configuration - Aastra OpenCom 100 Series Mounting And Commissioning User Manual

S Connector Module
2M
On the OpenCom 150 the pressure terminal is a 5-pin connector. The additional
terminal is used to connect the shielding of a shielded line. The shielding has to be
stripped as short as possible (approx. 3 mm).
6. If necessary, check to make sure that the NT is fed by its own power supply.
7. Reconnect the OpenCom 130 / 150 to the power supply.
8. Configure the S
2M
Configuration starting on page 79). Check the level 1 status with reference to the
LEDs on the module. None of the LEDs are illuminated before the S
been configured.
LED Display
LED
1 (green)
2 (green)
3 (yellow)
4 (red)
9. Pull out the mains plug of the OpenCom 130 / 150 again and close the housing.
10.Reconnect the OpenCom 130 / 150 to the power supply.

Configuration

The menu item S
2M
lation of the S module. Configure the port in the input mask of this menu item.
2M
Further information on this can be found in the online help.
74
module in the Configurator of the OpenCom 130 / 150 (refer to
appears in the Configurator, menu Telephony: Ports after instal-
Meaning
Synchronous (= ok)
Blue alarm
Remote alarm or out of sync
(yellow alarm)
Loss of signal (red alarm)
module has
2M