Aastra OpenCom 100 Series Mounting And Commissioning User Manual page 42

Installation
Configuring the slot
1. Log in to the Configurator as a user with administrator rights.
Switch to the Configurator's Expert mode to obtain all required dialogues.
2. Open the Telephony: Ports: Slots menu.
Card type a/b Trunk is displayed in the inserted column for the selected Slot if
the card is inserted into the slot.
Note
If the card type is not displayed, the interface card has not been detected. Ensure
that the interface card has been installed correctly.
3. Click on the desired entry in the Slot table.
4. Select card type a/b Trunk from the configured list.
5. Click on the Apply button.
Creating a new bundle
After you have configured the slot, the trunk lines need to be configured. Start by cre-
ating a new bundle:
1. Open the Telephony: Trunks: Bundle menu.
On the status page, the list of previously configured bundles is displayed.
2. Click on the New button.
3. Select the Analog trunk entry from the Access type list and enter a bundle name
in the Name field.
4. Fill in the other fields of the dialogue. The settings in the Max. time between
ringing pulses, Time to ready line and Time to ready dial out fields are man-
datory.
5. Click on the Apply button.
Assigning a route
In order to allow the analogue lines of the M100-AT4 Interface Card to be used for out-
going calls, the bundle needs to be assigned to a route:
40