Adjusting The Seat Tilt; Push Bar; Adjusting The Push Bar - Otto Bock Kimba Neo Instructions For Use Manual

8.4.3 Adjusting the seat tilt

1) Release the clamping lever (see fig. 99).
2) Set the seat angle to the desired position.
CAUTION! With one hand, secure the occupant against falling out (e.g. by holding his/her upper
body).
3) Tighten the clamping lever.
4) Press the backrest gently to the front/back to make sure that the seat angle is securely set. If this is not the
case, retighten the clamping lever.
99

8.4.4 Push bar

CAUTION
Lifting by removable components
User tipping over, falling due to lifting by removable components
► The product may be lifted only by firmly welded or permanently attached components. It is particularly danger­
ous to lift the product by the leg support, push handle/push bar, lap bar or arm supports.

8.4.4.1 Adjusting the push bar

The height of the push bar can be adjusted:
1) Loosen the clamping lever on both sides (see fig. 100).
2) Press the two buttons on both sides simultaneously (see fig. 100, item 1).
3) Move the push bar to the desired position.
4) Tighten the clamping lever (see fig. 100).
100
Kimba Neo, Kimba Cross, Kimba Inline
Use
49