Storage During Extended Disuse; Preparing The Product For Use; Assembly; Kimba Neo - Otto Bock Kimba Neo Instructions For Use Manual

5.3.2 Storage during extended disuse

The product must be stored in a dry place. Specific information for extended storage: see Page 56.
It is not necessary to disassemble the product.
Maintain sufficient clearance from sources of heat. If the product is parked for an extended period of time or the
tyres overheat (e.g. in the vicinity of radiators or in case of exposure to strong sunlight behind glass), the tyres may
become permanently deformed.
Direct exposure to sunlight or UV radiation causes the tyres to age more quickly. As a result, the tread surface
hardens and corner pieces break out of the tread.
The tyres should be replaced every 2 years regardless of wear and tear.

6 Preparing the product for use

6.1 Assembly

CAUTION
Exposed pinch points
Crushing, pinching due to incorrect handling
► When folding out the backrest, only grip by the specified components.
CAUTION
Improper assembly
Falling, tipping over of the user due to components coming off
► After each assembly, verify the proper fit of the removable wheels. The quick-release axles must be firmly
locked in the wheel attachment.
► Before using the product, the folding mechanism must be firmly locked in place.
► When attaching the seating unit, make sure you hear it engage into the outdoor mobility base.
► Secure the seating unit using the seat lock.

6.1.1 Kimba Neo

CAUTION
Incorrect adjustment of the tilt-limiter on the outdoor mobility base
User falls out due to user error
► Before mounting the seating unit on the outdoor mobility base, adjust the tilt-limiter as appropriate for the dir­
ection in which the seating unit will face.
► The tilt-limiter is adjusted on the outdoor mobility base. For information on adjusting the tilt-limiter, see the
instructions for use for the outdoor mobility base.
Attaching the rear wheels
1) If wheel locks are engaged: disengage wheel locks.
2) Depress the locks on the wheels (see fig. 4, item 1).
3) Push the rear wheels onto the axle until the lock clicks into place audibly.
Unfolding the rehab buggy (when the seating unit is detached)
1) Unfold the push bar (see fig. 5, item 1). To unfold the push bar: see Page .
2) Unfold the rehab buggy by pulling on the push bar (see fig. 5, item 2; see fig. 6).
→ The release handles of the folding mechanism engage automatically after unfolding (see fig. 5, item 3).
Kimba Neo, Kimba Cross, Kimba Inline
Preparing the product for use
17