Adjusting The Push Bar Height; Adjusting The Push Bar Angle; Wheel Lock; Engaging The Wheel Lock - Otto Bock Kimba Neo Instructions For Use Manual

Use

8.3.3.1 Adjusting the push bar height

1) Loosen the clamping lever on both sides.
2) Adjust the push bar to the desired height.
3) Tighten the clamping lever (see fig. 79, item 1).
79

8.3.3.2 Adjusting the push bar angle

1) Flip up the clip of the locking pin and pull out the locking pin.
2) Select the desired push bar angle.
3) Insert the locking pin through the hole in the back brace and secure it with the clip (see fig. 80)
80

8.3.4 Wheel lock

CAUTION
Wheel lock not engaged when getting in or out
Falling, tipping over of the user due to user error
► Before the user gets in or out, always engage and check the wheel lock.
► Engage the wheel lock to prevent the rehab buggy from moving on uneven ground or during transfers (e.g.
into a car).
NOTICE
Incorrect wheel lock operation
Damage to the wheels, loss of braking function due to improper operation
► Do not engage the wheel lock while driving. The product must be at a standstill before applying the wheel
lock.
► Do not engage the wheel lock with force.

8.3.4.1 Engaging the wheel lock

1) Pull the wheel lock levers to apply the drum brakes (see fig. 81, item 1).
2) By simultaneously moving the small wheel lock levers down, lock the wheel locks (see fig. 81 item 2).
3) Activate the wheel lock levers again to release the wheel locks (see fig. 81 item 1).
42 Kimba Neo, Kimba Cross, Kimba Inline