Using The Product In A Vehicle; Adjusting The Seating Unit; Adjusting And Securing The Seat Angle; Kimba Neo Seating Unit - Otto Bock Kimba Neo Instructions For Use Manual

Use

8.2.9.2 Using the product in a vehicle

WARNING
Positioning in vehicles for transporting persons with reduced mobility
Serious injuries in case of accidents due to user error
► Positioning of the product in vehicles for transporting persons with reduced mobility may only be performed
by the qualified personnel.
► The outdoor mobility base and the seating unit together must always face forwards when the product is used
as a seat in a vehicle for transporting persons with reduced mobility.
► Instruct the qualified personnel regarding the mounting points on your product described below.
WARNING
Inadequate transportation safety
Loss of safe restraint due to failure to observe transportation instructions
► Observe the following instructions for correct transport safety in the vehicle for transporting persons with
reduced mobility.
► If necessary, instruct the qualified personnel on the following information.
Further information on using the product Kimba Neo in a vehicle for transporting persons with reduced mobility is
found in the sections that follow.

8.2.9.3 Adjusting the seating unit

Before using the product in a vehicle for transporting persons with reduced mobility, the seating unit must be
adjusted in the driving direction (so the user faces forward in the direction of travel).
Kimba Neo seating unit: to remove/rotate and mount the seating unit, see the instructions for use (user), ref­
•
erence number 647H892.
• Alternative seating systems: to remove/rotate and mount the seating system, see the separate instructions
for use of the seating system.

8.2.9.4 Adjusting and securing the seat angle

8.2.9.4.1 Kimba Neo seating unit

Activating the locking mechanism
Before the product can be used in a vehicle for transporting persons with reduced mobility, the seat angle must be
adjusted horizontally and secured.
1) Turn the top rotary knob to the right and adjust the seat bottom so it is horizontal (see seating unit instructions
for use: reference number 647H893).
2) Pull the locking pin and allow it to engage in the opening provided in the seat adapter (see fig. 62).
3) To check, tilt the seat adapter against the locking pin (see fig. 63, item 1/2).
→ The seat adapter now has to be secured in both directions without play.
62
Deactivating the locking mechanism
After use in a vehicle for transporting persons with reduced mobility, the seat angle adjustment must be enabled
again.
1) Pull out the locking pin and secure it in the disengaged position by turning it (see fig. 64).
36
63
Kimba Neo, Kimba Cross, Kimba Inline