Settings During Preassembly; Adjusting The Seat Depth; Adjusting The Back Support Angle - Otto Bock Dino 3 Instructions For Use Manual

Settings
CAUTION
Sudden extension of gas compression springs
Impacts, pinching, crushing due to incorrect handling
► The gas compression springs must be fully extended when carrying out any work (seat tilt released, seat in the
neutral horizontal position).
► Never operate the release lever for the seat tilt when screw connections are loosened or when working on the
product.
► Secure the release lever for the seat tilt during all work to avoid operating it unintentionally.
Fine-tuning and adjustments should always be carried out in the presence of the user. The user should be sitting
upright in the wheelchair while making adjustments.
All parts of the product should be cleaned thoroughly before adjustments are made.
The tools required for adjustments and maintenance tasks as well as the torque values for screw connections are
listed in the section "Appendices" (see Page 28).

7.1.1 Settings during preassembly

If the seating shell/seating solution has already been preassembled, the following sections can be omitted:
• Section "Adjusting the seat depth" (see Page 12)
• Section "Adjusting the back support angle" (see Page 12)
• Section "Installing options/accessories" (see Page 8)

7.2 Adjusting the seat depth

CAUTION
Free-moving frame components
Crushing, pinching, impacts due to insufficient precautions
► Actively secure the back support frame, seat frame, cross tubes and gas compression spring against falling.
The seat depth can be adjusted in five steps by sliding the back support frame on the seat frame:
1) Loosen and remove the screw connections on the back support attachment devices, seat bars and rear cross
tube on both sides (see fig. 6, item 1).
2) Slide the back support attachment devices, back support frame and rear cross tube to the desired seat depth.
INFORMATION: Do not shift the position of the front cross tube and the gas compression spring
attached to it. This maintains the angle setting of the seat frame.
3) Reinsert all screw connections in the intended positions and firmly tighten them (see fig. 6, item 1).
INFORMATION: The bores on the lower edge of the back support attachment devices are used to
attach the front cross tube (not illustrated).
6

7.3 Adjusting the back support angle

Adjusting the back angle is described in more detail in the included instructions for use (user).
12 Dino 3