Installation With A Seat Facing In The Direction Of Travel - Otto Bock Kimba Neo Instructions For Use Manual

24

6.2.2 Installation with a seat facing in the direction of travel

Installing the T2 respirator platform
1) Glue the loop strap onto the front frame tube (see fig. 18).
INFORMATION: Trim the length to approx. 210 mm for size 1 and approx. 290 mm for size 2.
2) As shown in the image, glue the hook strap onto the angle tabs of the T2 respirator platform (see fig. 19).
3) Screw the supports onto the T2 respirator platform (see fig. 26, item 1).
INFORMATION: Only installing one support on the retaining bracket initially is recommended. The
second support is installed on the retaining bracket when the T2 respirator platform is mounted on
the front frame.
4) Set the T2 respirator platform onto the front frame tube (see fig. 27, item 1).
5) Engage the supports of the respirator platform in the lashing points and install (see fig. 28; see fig. 27 item 2).
→ The T2 respirator platform is installed (see fig. 27).
26
28
Installing the T1 respirator platform
1) As shown in the image, glue the hook strap onto the angle tabs of the T1 respirator platform (see fig. 19).
2) Screw the supports in place under the T1 respirator platform (see fig. 29, see fig. 30).
Kimba Neo, Kimba Cross, Kimba Inline
25
27
Preparing the product for use
23