In order to completely disconnect the front panel from the rest of the boiler, it should be turned around
the top horizontal edge while sweeping outwards through the user screen. The swept front panel should
not be at an angle bigger than 8 degrees with the front vertical surface of the boiler in order to protect the
top holes also with the top pins. If this is the case, the pins and the holes on the sheet metal may deform or
get ruptured.
Following these steps, the front panel should be rose upwards till the pins are free from the holes. The
front panel has now been unmounted.
Rev: RINNAI Service manual (English)
Date:14/05/2019
55