Advertisement
The parameter stick can copy the settings data from LMS 14 or to LMS 14 by this parameter.
The following operations will occur related with the choice:
No operation
stick.
Read from stick
Starts the reading process from stick. This is only possible for the readable sticks. The data set is copied to
LMS 14. Before the transfer starts, it is checked whether the data is appropriate for copying or not. If not,
the data set should not be copied. In this case the screen
operation or any error occurence.
If online DD is transferred, LMS 14 continues to operate
after the end of the transfer. If the parameters are
transferred, LMS 14 should be resetted after the end of
the transfer. While parametrizing (the transfer sequence)
parameterizing if no error occurs, after the end of
displayed.
Writing on stick
Starts the data writing sequence through LMS 14 to the stick. This operation is only possible with readable
sticks. The data is recorded onto the preset data. Before the data writing begins, stick checks whether if the
mem
displayed until the end of data writing or any fault occurence.
7253 PStick progress
This parameter value displays the percentage of the completed data writing job.
4.7.
LPG Adaptation of the Boiler
As factory setting, aiM boilers are set to operate with natural gas fuel. Whether if LPG will be used as fuel
for a single or a cascade system, all the boilers should be adapted to operate with LPG fuel. This adaptation
includes
-
Mounting the related orifice (who are given in the table below) between the gas valve and the
venturi of the boiler
Rev: RINNAI Service manual (English)
Date:14/05/2019
PStick progress
102
Advertisement
