Antenna Patterns In The Fcc Frequency Band - Siemens SIMATIC RF600 Series System Manual

Hide thumbs Also See for SIMATIC RF600 Series:
Table of Contents

Advertisement

Antennas
6.6 SIMATIC RF650A
6.6.6.2

Antenna patterns in the FCC frequency band

Directional radiation pattern FCC
The directional radiation pattern is shown for nominal alignment and a center frequency of
915 MHz.
Figure 6-44
Reference system
The half-power beam width of the antenna is defined by the angle between the two -3 dB
points (corresponding to half the power in relation to the maximum power). Which range (in
%) corresponds to the dB values in the patterns can be obtained from this table (Page 294).
Note that the measurements presented graphically below were carried out in a low-reflection
environment. Deviations can therefore occur in a normally reflecting environment.
292
System Manual, 11/2018, J31069-D0171-U001-A21-7618
SIMATIC RF600

Advertisement

Table of Contents
loading

Table of Contents