Ic-Fcb Information - Siemens SIMATIC RF600 Series System Manual

Readers
5.4 SIMATIC RF680R
5.4.7.2

IC-FCB information

Siemens SIMATIC RF680R (FCC): 6GT2811-6AA10-1AA0
IC:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d`Industrie Canada applicables aux appareils
radio exempts de licence. L`exploitation est autorisée aux deux conditions suivantes :
(1) L`appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l`appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d`en compromettre le fonctionnement.
Industry Canada Notice
To reduce potential radio interference to other users, the antenna type and its gain should be
so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
permitted for successful communication.
Transmitter power and antenna information for antennas with a gain less than 6 dBi:
This device has been designed to operate with the SIMATIC RF620A antenna 902-928, the
SIMATIC RF640A antenna 902-928 as well as the SIMATIC RF660A antenna 902-928 listed
below, and having a maximum gain of 5,5 dBi.
Arbitrary transmission power settings in combination with other antennas or antennas having
a gain greater than 5,5 dBi are strictly prohibited for use with this device.
The required antenna impedance is 50 Ohms.
Transmitter power and antenna information for antennas with a gain greater 6 dBi:
This device requires professional installation. Antennas with a gain greater 6 dBi may be
used provided the system does not exceed the radiation power of 4000 mW E.I.R.P. This
device has been designed to operate with the SIMATIC RF642A antenna 902-928 exceeding
the maximum gain of 5,5 dBi under the restriction that the RF power at the input of the
antenna must be set to meet the following relation: RF power (dBm) ≤ 30 dBm – (antenna
gain (dBi) – 6 dBi) Other antennas or system configurations for antennas having a gain
greater than 6 dBi are strictly prohibited for use with this device. The required antenna
impedance is 50 Ohms.
168
System Manual, 11/2018, J31069-D0171-U001-A21-7618
SIMATIC RF600