Appendix A. Installing Wireless Accessories; Installing The Via Emio-1533 Usb Wi-Fi Module; Figure 51: Installing The Via Emio-1533 Module To The Chassis; Figure 52: Connecting The Usb Wi-Fi Cable (Via Emio-1533) - VIA Technologies EPIA-P910 User Manual

Highly-integrated low-power platform with rich multimedia and i/o capabilities

Hide thumbs Also See for EPIA-P910:

Table of Contents

Appendix A. Installing Wireless Accessories

This chapter provides you with information on how to install the VIA EMIO wireless module into the VIA

EPIA-P910. It is recommended to use a grounded wrist strap before handling computer components.

Electrostatic discharge (ESD) can damage some components.

A.1. Installing the VIA EMIO-1533 USB Wi-Fi Module

Step 1

Mount the VIA EMIO-1533 module to the prepared standoff in the chassis. Align the two mounting holes

on the VIA EMIO-1533 module with the mounting holes on the standoffs. And then secure the VIA EMIO-

1533 module in place with two screws.

Step 2

Connect one end of USB Wi-Fi cable to the onboard USB 2.0 connector (WLAN) on VIA EPIA-P910-A I/O

expansion card, and then connect the other end of the cable to the VIA EMIO-1533 module.

Note:

Make sure the VIA EPIA-P910-A I/O expansion card is installed on the VIA EPIA-P910 before installing the VIA

EMIO-1533 module.

VIA EPIA-P910 User Manual

Table of Contents