2.1.1. Gigabit Ethernet Port
The integrated 8-pin Gigabit Ethernet port is using an 8 Position 8 Contact (8P8C) receptacle connector
commonly known as RJ-45. The Gigabit Ethernet port is controlled by VIA VT6130 PCIe Gigabit Ethernet
controller. The pinouts of the Gigabit Ethernet port are shown below.
Figure 5: Gigabit Ethernet port diagram
Pin
1
Signal pair 1+
2
Signal pair 1-
3
Signal pair 2+
4
Signal pair 3+
5
Signal pair 3-
6
Signal pair 2-
7
Signal pair 4+
8
Signal pair 4-
Table 3: Gigabit Ethernet port pinouts
The Gigabit Ethernet port has two individual LED indicators located on the front side to show its
Active/Link status and Speed status.
Link Off
The LED is always On in either Green or
Speed_10Mbit
Speed_100Mbit
Speed_1000Mbit
The LED is always On in Orange color
Table 4: Gigabit Ethernet LED color definition
2.1.2. USB 3.0 Port
The VIA EPIA-P910 is equipped with two USB 3.0 ports. Each USB 3.0 port has a maximum data transfer
rate of up to 5Gb/s and is backwards compatible with the USB 2.0 specification. The USB 3.0 ports
provides complete Plug and Play and hot swap capabilities for external devices. The pinouts of the USB
3.0 port are shown below.
Figure 6: USB 3.0 port diagram
Pin
1
2
3
4
5
Table 5: USB 3.0 port pinouts
Signal
Link LED
(Left LED on RJ-45 connector)
Off
Orange colors
The LED is always On in Green color
Signal
Pin
Signal
+5V
6
Rx+
Data-
7
GND
Data+
8
Tx-
GND
9
Tx+
Rx-
VIA EPIA-P910 User Manual
Active LED
(Right LED on RJ-45 connector)
Off
Flash in Yellow color
Flash in Yellow color
Flash in Yellow color
8