Side Slip Tester Sdl 410 - Bosch BSA 43 Series Original Instructions Manual

en 64 | BSA 43xx | Automatic mode
Step
4. Drive vehicle out of suspension tester.
6.2.3

Side slip tester SDL 410

Step
1. Check prerequisites:
R
No vehicle on dynamometer!
R
Tester/test routine selected.
R
"Automatic" mode selected.
2. Keeping the vehicle straight, drive both axles at
a constant speed over the side slip tester. Speed
max. 15 km/h.
|
1 691 606 210 2015-07-29
Result / Display
 Peak value display (approx. 5 seconds):
$
Road surface adhesion on left and right side (↓).
$
Difference in road surface adhesion (Δ)
$
Resonant frequency on left and right side (f)
$
Difference in resonant frequency (Δf)
"
Chassis measurement is over.
Result / Display
 Left: "Side slip tester" device symbol.
 Right: Drive-on prompt.
 Ready for toe measurement.
 Front axle toe is measured.
 Peak value display (approx. 5 seconds):
 Toe misalignment (<-->).
"
Toe measurement is over.
Robert Bosch GmbH