Current Measurement (Ch1 And Ch2); Continuity Tester (Ch1); Diode Measurement (Ch1); Wlan - Bosch KTS 340 Original Instructions Manual

en 18 | �TS ��� | Technical data
7.�.�

Current measurement (CH1 and CH2)

Sensor
Shunt (CH1 only)
30 A clamp (CH1 only)
100 A clamp
600 A clamp
1000 A clamp (CH1 only)
7.�.5

Continuity tester (CH1)

Property Value/Range
Measurement current 2 mA
No-load voltage ≤ 5 V
< 10  (with acoustic check-back)
Continuity
7.�.6

Diode measurement (CH1)

Property Value/Range
Measurement current 2 mA
No-load voltage ≤ 5 V
Maximum diode voltage 2 V
|
1 689 989 072 2010-06-09
Measuring range
±600 mA
±30 A
±100 A
±600 A
±1000 A
7.5

WLAN

Standard: IEEE 802.11g (54 Mbit/s), compatible with
IEEE 802.11b (11 Mbit/s), data encryption: OPEN, WPA,
WPA-PSK, WPA2, WPA2-PSK, WEP (64/128/256 bits),
antenna: -3dBi.
Radio link
�TS ��� to PC/laptop
Workshop environment with clear view
of access point
In vehicle interior with vehicle door or
window open and engine running
The range of the WLAN varies considerably.
20–40 m can normally be achieved indoors and up to
100 m outdoors.
Under adverse conditions the effective range may only
be 10–15 m or even less.
The KTS 340 automatically adapts the transmission
rate in the WLAN to the transmission conditions. In the
event of a poor radio link the data are transmitted
more slowly than with a good link.
Minimum range
30 meters
10 meters
Robert Bosch GmbH