Slide Switch; Calibration Mode; Set Mode; Test Mode - CAS CI-6000A Series Manual

3) Slide Switch

Calibration mode

SW1 DIP 1
Switch DIP 1 on
Switch DIP 1 off

Set mode

SW1 DIP 2
Switch DIP 2 on
Switch DIP 2 off

Test mode

SW1 DIP 3
Switch DIP 3 on
Switch DIP 3 off
It is used in calibration mode when zero value is high
SW2 DIP 1
If you set DIP 1 to on, zero value is decreased.
It is used in calibration mode when zero value is low
SW2 DIP 2
If you set DIP 2 to on, zero value is increased
Go to calibration mode
After calibration, it returns to weighing mode
Go to set mode.
After set mode, it returns weighing mode.
Go to test mode.
After test, it returns to weighing mode
13