Inputs And Outputs - Mircom TX3 Series Configuration Manual

Configure the SIP account details
1.
2.
See section 3.3 on page 36 for information on configuring the residents' SIP
accounts.
2.7

Inputs and Outputs

The default configurations for the 2 inputs are described below.
2.7.1 Input 1
By default, Input 1 is configured as a Door contact. Input 1 connects to the door
sense switch. When this input is active it means the door is open and when
inactive the door is closed.
TX3 Nano Configuration Manual
Copyright 2018
In the SIP Account Details section, provide information for each the
following:
Add OnSIP Account. If you have configured the TX3 Nano with an
OnSIP administrative account (section 2.3 on page 15), click Add OnSIP
Account to quickly create an OnSIP account for this TX3 Nano. The
Configurator enters the TX3 Nano's new OnSIP account details in the
fields.
If you do not have an OnSIP administrative account, then provide the
following information:
Username. The SIP username of the TX3 Nano.
Domain. The IP address or domain name of the SIP server.
Auth username. The authentication username of the TX3 Nano.
Password. The SIP password for the TX3 Nano.
Display name. This name appears on the resident's device when the TX3
Nano calls the resident.
Outbound proxy. The SIP server's proxy server, if required.
STUN server. Leave this blank unless your SIP service requires you to
change it.
Application layer gateway. Leave this as default (ALG) unless your SIP
service requires to you change it.
Transport. Leave this as default (UDP) unless your SIP service requires
to you change it.
Click Save Changes at the top of the window.
Nano Settings
23