Mircom TX3 Series Configuration Manual page 24

When access is granted, activation of the door sense switch locks the main door
and resets the Unlock door timer. This function is typically used to prevent
'tailgating'. Input 1 also, when configured with a correlation, activates a general
purpose output to perform any required function.
In addition, this input:
•
•
•
See section 2.8 on page 27 for information on configuring timers.
2.7.2 Input 2
By default, Input 2 is configured as General purpose.
2.7.3 Configure the Inputs
Configure inputs
1.
TX3 Nano Configuration Manual
24
Copyright 2018
senses if the door ever opened after it was unlocked as a result of access
being granted. If the door did not open even though the door was unlocked
for the programmed time duration, it is reported to the Configurator if the
Report door not open option is enabled (see section 2.8 on page
27).
senses a forced entry. If the door is locked and the door contact input
becomes active, the forced entry alarm activates. This can be changed by
selecting Disable forced entry alarm (see section 2.8 on page
27).
senses if the door is held open. This happens when the door is unlocked and
the door contact becomes active but does not get deactivated before the
Unlock door timer expires. At this time the door held open warning
timer starts. If the door is still open when this timer expires, a Door held
open trouble is reported to the Configurator.
When the door held open warning timer expires, the door held open alarm
timer starts. When the door held open alarm timer expires, a Door held
open alarm is reported to the Configurator.
If the door closes while the door held open warning timer or the door held
open alarm timer are active, the warning or alarm is cancelled, and the
Door open trouble restored or Door open alarm restored event is
reported to the Configurator.
Click Nano Setting in the left pane.
Nano Settings