Mircom TX3 Series Configuration Manual page 26

4.
2.7.4 Output
By default, the output is configured as a Lock. When access is granted, this
output unlocks the door. This output is deactivated when the Unlock door
for timer expires, or the door contact input becomes active.
Configure the output
1.
2.
3.
4.
TX3 Nano Configuration Manual
26
Copyright 2018
Open circuit
Short circuit
Open and short circuit
For more information on active state and supervision, see LT-6637 "TX3
Nano Installation Manual".
Delay. This specifies the amount of time in seconds before the input
generates an active event.
Click Save Changes at the top of the window.
Click Nano Settings in the left pane.
Click the Inputs & Outputs tab at the top of the window.
Select Output1 and provide the following information:
Label. Type a name for this output.
Assigned to. Select a function for this input:
Lock. When access is granted at the designated reader, the output
unlocks the door.
General purpose. The output assigned this function can perform any
required function, such as turning on a light.
Active state. Active state is the state in which the output is
considered active. Select one of the following:
Energized. When the device is energized it is considered to be active.
De-energized. When the device is de-energized it is considered to be
active.
Click Save Changes at the top of the window.
Nano Settings