Fault Codes - Pyronix Enforcer 32-WE Programming And Installation Manual

A p p e n d i x F .
If a device on the Enforcer 32-WE is not installed correctly or has lost its communication with the panel,
"DEVICE FAIL" will be shown on the keypad as shown:
Co nt ro l Pan el
485 Fa il Kp d
485 Fa il T rd
485 Fa il Zem
4 8 5 F a il O p m
For the keypad and tag readers, the top line will show the set point name, for the ZEMs and output
modules a 'Location' description (if inputted) will be shown on the top line of the display instead of the
address number. (Address number will be displayed in 2 digits, e.g.: 00,01,02 etc).
Wireless Fault Displays
Fault
Wireless mismatch
User name
Wireless Low Bat
Input name
Wireless Low Bat
Siren n
Wireless Low Bat
Input name
Wireless Supervision
fault
Siren n
Wireless Supervision
fault
Input name
Tamper Alarm
Siren n
Tamper Alarm
Location
Wireless Jam WZm
"Input name"
Or "Siren n" Wirless
Poll Fail
F a u l t C o d e s
= Mai n pa ne l fau lt (e .g . ba tte ry)
= Ke ypad
= Tag Rea de r / Door Sta t ion / T MZ
= Zon e Expan der Mod ul e (Z EM)
= O ut p u t Mod ul e
Description
There is an input learnt without
having a type assigned to it
Low battery on radio keyfob for the
user with the name shown on the
top line.
Low battery on radio input, entered
name of input shown on top line.
Low battery on radio bell number 'n'
Radio input whose name is shown on
the top line hasn't 'checked in'
Radio bell number 'n' hasn't
'checked in'
Tamper fault on radio input whose
name is shown on the top line
Tamper fault on radio bell number
'n'
Jamming fault on the wireless ZEM
whose location is shown on the top
line
No 'polls' are received for 20
minutes before the set operation
Solution
Assign an input type in 'Change
Inputs'.
Replace the battery on the
mentioned keyfob.
Replace the battery on the
mentioned input device.
Replace the battery on the
mentioned radio bell.
Walk test the detector, perform a
diagnostic – signal strength test and
try replacing the battery.
Test the siren, perform a diagnostic
– signal strength test and try
replacing the battery.
Check the tamper switch on
mentioned radio input; check that
the case is closed properly.
Check the tamper switch on the
mentioned radio bell.
Check no radio interference is in
close proximity to the radio
devices/panel.
Test the signal strength / battery on
the device shown.
Page: 55